apt update && apt upgrade -y
Step 1 — Install WireGuard
add-apt-repository ppa:wireguard/wireguard
apt update
apt install wireguard
apt autoremove dnsmasq
reboot
nano /etc/network/interfaces
echo nameserver 1.1.1.1 | sudo tee /etc/resolv.conf
netplan apply
sudo ufw allow 80
sudo ufw allow 443Also, as port 51820/udp is the default WireGurad port, we need to make sure that it is open as well:
sudo ufw allow 51820/udpStep 2 — WireGuard modules
modprobe wireguard
modprobe iptable_nat
modprobe ip6table_nat
Once the modules have been enabled you need to run the following commands in order to enable the modules when the server gets rebooted:
echo "wireguard" | sudo tee /etc/modules-load.d/wireguard.conf
echo "iptable_nat" | sudo tee /etc/modules-load.d/iptable_nat.conf
echo "ip6table_nat" | sudo tee /etc/modules-load.d/ip6table_nat.confFinally check if systemd-modules-load service is active:
sudo systemctl status systemd-modules-load.service
Step 3 – Enable packet Packet forwarding
In order to get WireGuired to work as expected, we need to make sure that package forwarding is enabled. Packet forwarding means allowing packets to go from one network to another.
To do that you need to run the following commands:
sudo sysctl -w net.ipv4.ip_forward=1
sudo sysctl -w net.ipv6.conf.all.forwarding=1- INSTALL DOCKER
apt install apt-transport-https ca-certificates curl gnupg-agent software-properties-common
curl -fsSL https://download.docker.com/linux/ubuntu/gpg | sudo apt-key add
sudo add-apt-repository “deb [arch=amd64] https://download.docker.com/linux/ubuntu bionic stable”
sudo apt update
install docker….
apt-get install docker-ce docker-ce-cli containerd.io
systemctl start docker
systemctl status docker
systemctl enable docker
systemctl daemon-reload
docker create \
–name subspace \
–restart always \
–network host \
–cap-add NET_ADMIN \
–volume /usr/bin/wg:/usr/bin/wg \
–volume /data:/data \
–volume /lib/x86_64-linux-gnu/libc.so.6:/lib/x86_64-linux-gnu/libc.so.6:ro \
–volume /lib64/ld-linux-x86-64.so.2:/lib64/ld-linux-x86-64.so.2:ro \
–env SUBSPACE_HTTP_HOST=89.111.246.195 \
–env SUBSPACE_NAMESERVER=1.1.1.1 \
subspacecommunity/subspace:latest
Then start your container:
sudo docker start subspacedocker logs subspace